Okidata Alignment Checklist

<< Click to Display Table of Contents >>

Navigation:  Hardware Topics > Printers > Recommended Printers > Setting Up The Okidata 320 Turbo >

Okidata Alignment Checklist

Previous pageReturn to chapter overviewNext page

Printing too low

Verify form code and revision date

Reset top of form

If it is a non-turbo printer, make sure "NON-Turbo" is selected in Printer Setup

If it is a non-turbo printer, make sure the form is fed to the top red line

Printing too high

Verify form code and revision date

Reset top of form

If it is a turbo printer, make sure "Turbo" is selected in Printer Setup

If it is a non-turbo printer, make sure the form is fed to the top red line

Printing too far to the left

Verify form code and revision date

Printing too far to the right

Verify form code and revision date

Move gray guide towards the right

Printing inconsistently

Verify form code and revision date

Reset the printer to factory settings, go through printer setup

Verify that the form is being loaded straight along the gray guide

Verify that the top of the form is straight relative to the red line