|
<< Click to Display Table of Contents >> Name Update |
  
|
|
<< Click to Display Table of Contents >> Name Update |
|
***Internet connection is required and updates MUST be done from the main server computer for Frazer. All sub-windows should be closed in the program and Frazer should be closed on all workstation computers.
If the dealership has recently changed its name, address, and/or phone number and has notified Frazer either by email or by calling support, we will prepare an update.
If you are on the phone with a member of support, they will make the necessary changes and direct you to the "Update Forms Only" button in Frazer.
It can be found by going to Updates, along the top of Frazer.
Once downloaded, the following screen will appear:
Click on Next.
On the following screen, be sure that the destination folder shown is where the Frazer program is installed on the server.
Continue through the following screens by clicking Next.
The program will close automatically, then after a few moments reopen to update several data files, including forms, with the new dealership information. When the process completes, the update is finished and the program may be opened again.
To confirm the dealership information, go to Help at the top, then 4- About Frazer.
The dealership’s information is located in the middle under System Licensed to.
Possible errors:
A possible error can occur if Frazer is open on any workstation computers, or if sub-windows are open.
A warning message will appear.
Verify the program is not open or minimized on any workstation computers and all sub-windows on the main are closed.
If the program is closed, but the message still appears, restart the main computer and run the update again.
Local Firewall Settings and Proxies could prevent Frazer from accessing the internet, and affect certain aspects of the program.
If you suspect this may be the case, have your local technician check your network and internet settings.
See Also:
.